Skip to main content

Gavle v1.5 Manual

Important

  • DON’T LEAVE LAUNCHER CHARGED WITH CO2. IT WILL BREAK.
  • PUNCTURE CYLINDER WHEN READY TO SHOOT.
  • MAX PRESSURIZATION TIME: 5 MINUTES
  • DEGAS ASAP AFTER USE. DO NOT FORGET.
  • OPERATING TEMPERATURE: 40°F – 110°F
  • USE only 12 GRAM CO2

General Warnings

Power: 36 Joules | 26.6 Ft-Lbs

  • May result in injury or death.
  • Use with caution.
  • Not a toy.
  • Not intended for paintball or recreational use.
  • Avoid aiming at face, head, or other sensitive
  • areas of the body.
  • Read instructions before use.

Never point the launcher in any direction you do not wish to discharge it at. (Basic gun safety)

While practicing or performing maintenance, you MUST wear safety or ballistic glasses or goggles which are at least ANSI z87.1 certified.

Bolt Warning

The bolt is under high spring pressure. When replacing the bolt o’ring, cleaning the bolt or applying silicone for maintenance, please use caution. Remove the back cap. Then remove the bolt guide. The bolt and spring are underneath the bolt guide, held in place with a white plastic ring, set in a groove. If the ring becomes dislodged, the bolt will be propelled out of the launcher with high force. Please do not look into the air chamber while removing parts. Wear safety glasses. The procedure to replace the bolt and ring will be covered later in the manual. You should be able to fire over 100 rounds between maintenance cycles.

Co2 Caution

Do not heat CO2 cartridges or leave them in a hot place (like an automobile with closed windows). You can unscrew the CO2 cartridge and take it with you, leaving the launcher.

Operating Conditions

Loading the Gavle

Replacing the bolt O’ring

Assembly

If you need to clean, lubricate, or replace the white o’ring under the bolt guide. 

© 2023 Grimburg | cs@grimburg.me | 207.256.9762